Music stands can be found in several varieties and styles, and can be produced from a variety of materials. But with few exceptions, each of them share exactly the same basic parts. From lower to upper these consist of the “base”, the “shaft”, and the “tray”.
The base of any sheet music stand will most often have three legs and be of either a tri-pod or standard, fixed-base design. A tri-pod base attach’s the tops from the legs to the shaft part way up from the floor, with three bottom contact points on the ground. These types of legs are more often than not foldable or collapsible. Practically all folding and portable sheet music stands are created this way. A stand using a standard base may also frequently have three contact points on the ground, nevertheless the opposite end of the legs will most likely be steel-welded to the foot of the shaft. This may provide the stand more stability, and definitely will sacrifice the capability of the stand to easily fold down into a reduced space for additional convenient carrying. Most stands present in schools are of the type.
The center portion of the music stand, which connects the base using the tray, is the shaft. In the event the stand is height- adjustable, then probably the shaft may have two tubes, one within the other. These tubes will telescope and then lock in the desired height. In case a stand has a standard base, then it is highly likely that the shaft will likely be of a “one piece” design. That is certainly, the outer tube will be a single piece and will not collapse to the shorter compared to minimum playing height. In case a stand includes a tri-pod base, it could have a one, two, or three-piece shaft (or maybe more). Multiple-piece shafts will either telescope as a result of a really small size for simplicity of transport, or the pieces will separate and so take up much less room next to each other. Naturally, the single piece shaft is considered the strongest, however, folding and portable music stand shafts are becoming stronger in the recent years.
The part of Wood Music Stand which actually holds the music is commonly called the tray or even the “desk”. The tray consists mainly of two parts. The vertical backing is called the “bookplate”, and is usually either one particular, solid piece, or is constructed from several interconnecting bars who have spaces between the two (as with folding stands). The diieaz support (which will keep the written music from falling towards the floor) is called the “shelf” or even the “lip”. The typical depth of the shelf is approximately 2 “, but this could vary depending on the intended utilization of the stand. When a musician plans to read music from books, for example, then this stand using a deeper shelf could be needed. The shelf usually may come as either one particular, attached piece, or is by two parts which fold together at the middle. The complete tray (bookplate plus shelf) might or might not be adjustable for tilt angle, and varies in dimensions and strength.
Written Music Stand Differences
These are the basic elements of the majority of music stands you will encounter. A lot of the exceptions are usually in favor of artistic design and are available from stands which are very beautiful, but sometimes not easily portable. Some examples include music stands with solid (legless) bases, duel-shafted stands, and jazz or “big band” style cardboard stands. And given that there are many written music stand designs, having a grasp from the basic workings of one of the most important pieces of equipment a musician will make use of is helpful for 2 reasons. Growing your general musical knowledge is usually important; and becoming knowledgeable about these specific terms could make you better capable of compare different stands for your musical needs.